Cisco WS-C6506 - Page 1282

52-50
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 52 Configuring QoS
Configuring QoS on the Switch
This example shows how to create an IP ACE for the IPINIP traffic:
Console> (enable) set qos acl ip my_IPacl trust-ipprec microflow my-micro aggregate my-agg
ipinip any any
my_IPacl editbuffer modified. Use ‘commit’ command to apply changes.
Console> (enable)
IP ACEs for Any IP Traffic
To create or modify an IP ACE that matches all IP traffic, perform this task in privileged mode:
This example shows how to create an IP ACE:
Console> (enable) set qos acl ip my_IPacl trust-ipprec microflow my-micro aggregate my-agg
any
my_IPacl editbuffer modified. Use ‘commit’ command to apply changes.
Console> (enable)
Modifying the Default IP ACLs
These sections describe how to modify the default IP ACLs:
• Modifying the Default IP Ingress ACL, page 52-50
• Modifying the Default IP Egress ACL, page 52-51
Modifying the Default IP Ingress ACL
To modify the default IP ingress ACL, perform this task in privileged mode:
Note Only PFC3 supports the input keyword.
For more information, see the “Default ACLs” section on page 52-22.
Task Command
Step 1
Create or modify an IP ACE. set qos acl ip acl_name {dscp dscp | trust-cos |
trust-ipprec | trust-dscp} [microflow
microflow_name] [aggregate aggregate_name]
src_ip_spec [precedence precedence | dscp-field
dscp] [before editbuffer_index | modify
editbuffer_index]
Step 2
Verify the configuration. show qos acl info {acl_name | all}
editbuffer [editbuffer_index]
Task Command
Step 1
Modify the default IP ACL. set qos acl default-action ip {dscp dscp |
trust-cos | trust-ipprec | trust-dscp} [microflow
microflow_name] [aggregate aggregate_name]
[input]
Step 2
Verify the configuration. show qos acl info default-action {ip | ipx | mac |
all}