Cisco WS-C6506 - Page 1466

Index
IN-18
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
overview 14-6
source-destination-ip 14-6
source-destination-vlan 14-6
flows 14-4
completely and partially switched 13-9, 14-10
completely and partially switched multicast 13-9,
14-10
guidelines 14-13
Layer 2 forwarding table 14-5
monitoring on MSFC 13-22, 14-17, 14-35
MSFC
disabling on interfaces
14-16
displaying interface information 13-21, 14-34
enabling globally 14-32
enabling on interfaces 13-20, 14-16, 14-33
monitoring 13-22, 14-17, 14-35
multicast routing table, displaying 14-34
PIM, enabling 14-33
threshold 13-19, 14-33
MTU size
IP
14-14
IPX 14-16
NetFlow table entries, displaying 13-26
packet rewrite 14-2
packet threshold values for IP 14-21
restrictions
for IP MMLS, MSFC
14-15
for IP MMLS, switches 14-14
route-processor (note) 14-32
routers
enabling globally
13-18
multicast routing table, displaying 13-21
PIM, enabling 13-19
routing command restrictions 14-14
setting minimum flow mask 14-21
specifying aging time 14-19
specifying fast aging time 14-21
statistics
clearing
13-36, 14-31
displaying by protocol 14-30
displaying for MLS cache entries 14-30
switches
cache entries, displaying
14-39
configuration, displaying 14-38
disabling (note) 14-19
NetFlow table entries, displaying 13-26
statistics, clearing 13-26, 14-39
statistics, displaying 13-25, 14-38
topology (figure) 14-11
unsupported IP MMLS features 14-15
mls ip multicast command
enabling IP MMLS
50-35, 50-36, 50-37
MMLS
See MLS
modules
checking status
20-2
designating on command-line 2-5
downloading software images 27-8, 27-17
status, checking 20-2
supervisor engine
configuring
3-1
monitoring
memory usage
20-21
system warnings 20-19
MOTD
See login banner
MSFC
accessing from switch
console port
2-3
telnet session 2-4
AppleTalk interVLAN routing, configuring 12-4
as MLS route processor for Catalyst 5000 family
switches
14-16
booting for the first time 3-4
configuration guidelines
interVLAN routing
12-2
IP MMLS 14-15
MLS 14-13