Index
IN-19
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
configuration mode 2-10
configuring
Appletalk interVLAN routing
12-4
interVLAN routing 12-1
IP interVLAN routing 12-3
IP MMLS 14-32
IPX interVLAN routing 12-3
MLS 14-16
MMLS threshold 13-19, 14-33
redundancy with HSRP 23-28
configuring redundancy 23-21
displaying IP MMLS interface information 13-21,
14-34
enabling
IP multicast routing
14-32
MMLS on MSFC interfaces 13-20, 14-33
IP interVLAN routing, configuring 12-3
IP MMLS, monitoring 13-22, 14-35
IPX interVLAN routing, configuring 12-3
multicast routing table, displaying 14-34
overview 12-1
PIM, enabling on MSFC interfaces 14-33
session command and 2-4
switch console command and 2-3
MSFC2
Catalyst 5000 support
13-1
configuring
IP multicast
13-18
unicast Layer 3 switching 13-16
enabling IP multicast routing 13-18
multicast routing table, displaying 13-21
PIM, enabling on MSFC2 VLAN interfaces 13-19
MST 7-16
boundary ports 7-22
bridge ID priority 7-54
configuration 7-21
configuring 7-51
edge ports 7-23
enabling 7-51
hop count 7-23
instances 7-21
interoperability 7-19
interoperability with PVST+ 7-17
link type 7-23
mapping VLANs to 7-58
message age 7-23
port cost 7-55
port instance cost 7-56
port instance priority 7-57
port priority 7-56
region 7-22
regional root 7-22
regions 7-21
MSTP
M-record
7-17
M-tree 7-17
MTU
IP MLS and
14-14
IPX MLS and 14-16
multicast
groups
leaving
50-5
See IP multicast
multicast suppression
35-2, 50-7
multicast traffic, rate limiting 50-14
Multilayer Switch Feature Card
See MSFC or MSFC2
Multilayer Switching
See MLS
Multilayer Switch Module
See MSM
A-3
multiple forwarding paths 7-16
Multiple Spanning Tree
See MST
7-16
Multiple VLAN Registration Protocol
See MVRP
MVRP
clearing