Cisco WS-C6506 - Page 18

Contents
xviii
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Displaying Transceiver Information 20-73
Setting Transceiver Monitoring and Thresholds 20-77
CHAPTER 21 Configuring GOLD 21-1
Understanding How Online Diagnostics Work 21-1
Configuring Online Diagnostics 21-2
Specifying the Bootup Online Diagnostic Level 21-2
Configuring On-Demand Online Diagnostics 21-3
Configuring Online Diagnostic Health-Monitoring Tests 21-8
Scheduling Online Diagnostics 21-9
Specifying the Online Diagnostic Failure Response 21-10
Specifying the Online Diagnostic Event Log Size 21-10
Displaying Online Diagnostic Tests and Test Results 21-11
Clearing the Online Diagnostic Configuration 21-11
CHAPTER 22 Administering the Switch 22-1
Setting the System Name and System Prompt on the Switch 22-2
Setting the Static System Name and Prompt 22-2
Setting the System Contact and Location on the Switch 22-3
Setting the System Clock on the Switch 22-4
Creating a Login Banner on the Switch 22-4
Configuring a Login Banner 22-5
Clearing a Login Banner 22-5
Displaying or Suppressing the “Cisco Systems Console” Telnet Login Banner on the Switch 22-5
Defining Command Aliases on the Switch 22-6
Defining IP Aliases on the Switch 22-7
Configuring Static Routes on the Switch 22-8
Configuring Permanent and Static ARP Entries on the Switch 22-9
Scheduling a System Reset on the Switch 22-10
Scheduling a Reset at a Specific Time 22-10
Scheduling a Reset Within a Specified Amount of Time 22-11
Power Management 22-12
Enabling or Disabling Power Redundancy 22-12
Using the CLI to Power Modules Up or Down 22-14
Environmental Monitoring 22-14
Environmental Monitoring Using CLI Commands 22-15
LED Indications 22-15
Displaying System Status Information for Technical Support 22-16