Contents
xxxii
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
SNMPv1 and SNMPv2c Default Configuration 47-11
Configuring SNMPv1 and SNMPv2c from an NMS 47-11
Configuring SNMPv1 and SNMPv2c from the CLI 47-11
SNMPv1 and SNMPv2c Enhancements in Software Release 7.5(1) 47-12
Setting Multiple SNMP Community Strings 47-13
Clearing the SNMP Community Strings 47-14
Specifying the Access Numbers for Hosts 47-14
Clearing the IP Addresses Associated with Access Numbers 47-15
Specifying, Displaying, and Clearing an Interface Alias 47-16
Configuring SNMPv3 on the Switch 47-16
SNMPv3 Default Configuration 47-16
Configuring SNMPv3 from an NMS 47-16
Configuring SNMPv3 from the CLI 47-17
CHAPTER
48 Configuring RMON 48-1
Understanding How RMON Works 48-1
Enabling RMON on the Switch 48-2
Viewing the RMON Data 48-2
Supported RMON and RMON2 MIB Objects 48-3
CHAPTER
49 Configuring SPAN, RSPAN and the Mini Protocol Analyzer 49-1
Understanding How SPAN and RSPAN Work 49-1
SPAN Session 49-2
Destination Port 49-2
Source Port 49-2
Ingress SPAN 49-3
Egress SPAN 49-3
VSPAN 49-3
Trunk VLAN Filtering 49-4
SPAN Traffic 49-4
Understanding How the Mini Protocol Analyzer Works 49-4
Mini Protocol Analyzer Session 49-5
SPAN, RSPAN and Mini Protocol Analyzer Session Limits 49-5
Configuring SPAN on the Switch 49-6
SPAN Hardware Requirements 49-6
Understanding How SPAN Works 49-6
SPAN Configuration Guidelines 49-7
Configuring SPAN from the CLI 49-8
To Next Page
Loading...
