Cisco WS-C6506 - Page 342

13-24
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 13 Configuring CEF for PFC2 and PFC3A
Configuring CEF for PFC2/PFC3A on the Switch
Using the Debug Commands
Table 13-3 describes the IP MMLS-related debug troubleshooting commands.
Using the Debug Commands on the SCP
Table 13-4 describes the Serial Control Protocol (SCP)-related debug commands to troubleshoot the
SCP that runs over the Ethernet out-of-band channel (EOBC).
Displaying the IP Multicast Information on the Supervisor Engine
These sections describe how to display the IP multicast information:
• Displaying the IP Multicast Statistics, page 13-25
• Clearing the IP Multicast Statistics, page 13-26
• Displaying the IP Multicast Entries, page 13-26
Table 13-3 IP MMLS Debug Commands
Command Description
[no] debug mls ip multicast group
group_id group_mask
Configures filtering that applies to all other multicast
debugging commands.
[no] debug mls ip multicast events Displays the IP MMLS events.
[no] debug mls ip multicast errors Turns on the debug messages for multicast MLS-related
errors.
[no] debug mls ip multicast messages Displays the IP MMLS messages from/to the hardware
switching engine.
[no] debug mls ip multicast all Turns on all the IP MMLS messages.
[no] debug mdss error Turns on the Multicast Distributed Switching Services
(MDSS) error messages.
[no] debug mdss events Turns on the MDSS-related events.
[no] debug mdss all Turns on all the MDSS messages.
Table 13-4 SCP Debug Commands
Command Description
[no] debug scp async Displays the trace for asynchronous data in and out of the
SCP system.
[no] debug scp data Shows the packet data trace.
[no] debug scp errors Displays the errors and warnings in the SCP.
[no] debug scp packets Displays the packet data in and out of the SCP system.
[no] debug scp timeouts Reports timeouts.
[no] debug scp all Turns on all SCP debugging messages.