14-34
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 14 Configuring MLS
Configuring MLS
To enable IP MMLS on an MSFC interface, perform this task:
This example shows how to enable IP MMLS on an MSFC interface:
Router(config-if)# mls ip multicast
Router(config-if)#
Use the no keyword to disable IP MMLS on an MSFC interface.
Displaying IP MMLS Interface Information
The show ip pim interface count command displays the IP MMLS enable state on the MSFC IP PIM
interfaces and the number of packets that are received and sent on the interface.
The show ip interface
command displays the IP MMLS enable state on an MSFC interface.
To display the IP MMLS information for an IP PIM MSFC interface, perform one of these tasks:
Displaying the IP Multicast Routing Table
The show ip mroute command displays the IP multicast routing table on the MSFC.
To display the IP multicast routing table, perform this task:
This example shows how to display the IP multicast routing table for 239.252.1.1:
Router# show ip mroute 239.252.1.1
IP Multicast Routing Table
Flags:D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT
M - MSDP created entry, X - Proxy Join Timer Running
A - Advertised via MSDP
Outgoing interface flags:H - Hardware switched
Timers:Uptime/Expires
Task Command
Enable IP MMLS on an MSFC interface. Router(config-if)# [no] mls ip multicast
Task Command
Display IP MMLS interface information. Router# show ip pim interface [type number] count
Display the IP MMLS interface enable state. Router# show ip interface
Task Command
Display the IP multicast routing table. Router# show ip mroute [group[source]] |
[summary] | [count] | [active kbps]
To Next Page
Loading...
Need help?
General