Cisco WS-C6506 - Page 392

14-36
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 14 Configuring MLS
Configuring MLS
Group delete Ack:0
Global delete sent:7
Global delete Ack:7
L2 entry not found error:0
Generic error :3
LTL entry not found error:0
MET entry not found error:0
L3 entry exists error :0
Hash collision error :0
L3 entry not found error:0
Complete flow exists error :0
This example shows how to display information on a specific IP MMLS entry on the MSFC:
Router# show mls ip multicast 224.1.1.1
Multicast hardware switched flows:
(1.1.13.1, 224.1.1.1) Incoming interface: Vlan13, Packets switched: 61590
Hardware switched outgoing interfaces: Vlan20 Vlan9
RFD-MFD installed: Vlan13
(1.1.9.3, 224.1.1.1) Incoming interface: Vlan9, Packets switched: 0
Hardware switched outgoing interfaces: Vlan20
RFD-MFD installed: Vlan9
(1.1.12.1, 224.1.1.1) Incoming interface: Vlan12, Packets switched: 62010
Hardware switched outgoing interfaces: Vlan20 Vlan9
RFD-MFD installed: Vlan12
(1.1.12.3, 224.1.1.1) Incoming interface: Vlan12, Packets switched: 61980
Hardware switched outgoing interfaces: Vlan20 Vlan9
RFD-MFD installed: Vlan12
(1.1.11.1, 224.1.1.1) Incoming interface: Vlan11, Packets switched: 62430
Hardware switched outgoing interfaces: Vlan20 Vlan9
RFD-MFD installed: Vlan11
(1.1.11.3, 224.1.1.1) Incoming interface: Vlan11, Packets switched: 62430
Hardware switched outgoing interfaces: Vlan20 Vlan9
RFD-MFD installed: Vlan11
Total hardware switched installed: 6
Router#
This example shows how to display a summary of the IP MMLS information on the MSFC:
Router# show mls ip multicast summary
7 MMLS entries using 560 bytes of memory
Number of partial hardware-switched flows:2
Number of complete hardware-switched flows:5
Router#
Using Debug Commands on the IP MMLS MSFC
Table 14-9 describes the IP MMLS-related debug troubleshooting commands.