15-123
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 15 Configuring Access Control
Downloadable ACLs
To display the IP phone information that has been detected on a port on which downloaded ACLs are
present, perform this task in enable mode:
This example shows how to display host information on a port:
Port IP Address
----- ------------------------------
3/45 10.1.1.5
To display the ACL name downloaded for a feature in addition to the port-specific information, perform
this task in enable mode:
This example shows how to display the ACL name downloaded for a feature and port-specific
information:
Console> (enable) show port dot1x 3/45
Port Auth-State BEnd-State Port-Control Port-Status
----- ------------------- ---------- ------------------- -------------
3/45 authenticated idle auto authorized
Port Port-Mode Re-authentication Shutdown-timeout Control-Mode
admin oper
----- ------------- ----------------- ---------------- ---------------
3/45 SingleAuth disabled disabled Both Both
Port Posture-Token Critical-Status Termination action Session-timeout
----- ------------- --------------- ------------------ ---------------
3/45 - no NoReAuth -
Port Session-Timeout-Override Url-Redirect
----- ------------------------ -------------------------------
3/45 disabled -
Port Critical Port-Name
----- -------- ---------
3/45 disabled -
Port Downloaded ACL
----- -------------------------------------------
3/45 #ACSACL#-IP-testacl-44c7197a
Task Command
Display the IP phone information on a
port.
show security acl downloaded-acl ipphone-map
Task Command
Display the ACL name downloaded for a
feature and port-specific information.
show port [dot1x| web-auth | eou | mac-auth-bypass ]
mod/port
To Next Page
Loading...
