20-68
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 20 Checking Status and Connectivity
Configuring the Ethernet Local Management Interface
E-LMI parameters for port 7/1
Port Ethernet LMI: Enabled
Operational Status: Disabled
Mode: PE
T391: NA
T392: 15
N391: NA
N393: 4
Console <enable>
Clearing an EVC
To clear an EVC configured in the switch, perform this task in privileged mode:
This example shows how to clear EVC1:
Console> (enable) clear ethernet-evc EVC1
EVC1 is successfully cleared.
Console> (enable)
Clearing an EVC on an Individual Port Associated to a UNI
To clear any EVCs associated to the UNI or a specified EVC, perform this task in privileged mode:
This example shows how to clear EVCs associated with module 7, port 1:
Console> (enable) clear port ethernet-evc 7/1
EVCs associated with port 7/1 are cleared.
Console> (enable)
Clearing ELMI Statistics Counters
To clear ELMI statistics counters for all ports or a specified port, perform this task in priviledged mode:
This example shows how to clear ELMI statistics associated with module 7, port 1:
Console> (enable) clear port ethernet-lmi 7/1 statistics
Ethernet LMI statistics cleared on port 7/1.
Console> (enable)
Task Command
Clear an EVC configured in the switch. clear ethernet-evc [evc_id]
Task Command
Clear an EVC configured in the switch port. clear port ethernet-lmi mod/portstatistics
Task Command
Clear ELMI statistics counters. clear port ethernet-evc mod/port [evc_id]
To Next Page
Loading...
