- 417 -
●MSW4-5: Position detect
[Outline] Selects the method of detecting paper position.
OFF(0) ON(1)
Position detect Blackmark Label
ON(1) OPERATION: Detects paper position by detecting the inter-label distance.
OFF (0) OPERATION:Detects the paper position by detecting the black mark.
*This function is valid only with black mark specification or label specification.
*If thermal roll paper is selected by MSW4-4, this function is invalid.
*Black mark detection is fixed with black mark specification.
●MSW4-5： Mechanism mounted (Only for PMU2XXX/PMU2XXXII)0
[Outline] Set the mechanism mounted on the printer
OFF(0) ON(1)
Mechanism mounted
LT-23XX LT-22XX
ON(1) OPERATION: LT-22XX (2inch mechanism)
OFF (0) OPERATION: LT-23XX (3 inch mechanism)
●MSW4-6： Paper Change
[Outline] On label modelsor black mark models, auto length measurement can be performed at cover close for
using different paper. This memory switch sets this function enabled or disabled.
OFF(0) ON(1)
Paper Change
Invalid Valid
ON(1) OPERATION: Auto length measurement isdone at coverclose.
OFF (0) OPERATION: Auto length measurementisNOTdone at coverclose.
●MSW4-6: Behavior by cover close
[Outline] Selectsthebehavior at closing cover for black mark or label
OFF(0) ON(1)
C.Close Action Find TOF Auto Measure
ON(1) OPERATION: Feedpaper tofindtop ofform
OFF (0) OPERATION: MSW4-1 On -Performs automatic length measurement.
MSW4-1 Off -Does notperform automatic length measurement.
To Next Page
Loading...
