ComAp InteliDrive Lite - 2 System Overview; What Describes this Manual; Warnings; General Description

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
13
2 System overview
2.1 What describes this manual?
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important instructions for ID-FLX-Lite controllers family that shall be followed
during installation and maintenance of the InteliDrive Lite engine controllers.
This manual describes ID-FLX-Lite application examples for single engine applications.
This manual provides general information how to install and operate InteliDrive Lite controller.
This manual is intended for operators of engines, for engine control panel builders or for everybody
who is concerned with installation, operation and maintenance of the engine applications.
2.2 Warnings
InteliDrive Lite controller can be remotely controlled. In case of the work on the engine check, that
nobody can remotely start the engine.
To be sure:
Disconnect remote control via RS232 line,
Disconnect input REM START/STOP or
Disconnect output STARTER
NOTE:
Because of large variety of InteliDrive Lite parameters setting, it is not possible to describe all
combination. Some of InteliDrive Lite functions are subject of changes depend on SW version.
The data in this manual only describes the product and are not warranty of performance or
characteristic.
NOTE:
SW and HW must be compatible (e.g. ID-FLX-Lite firmware and ID-FLX-Lite hardware) otherwise the
function will be disabled. If wrong software is uploaded the message HARDWARE INCOMPATIBLE
appears on the controller screen.
In the case of using Boot load (jumper) programming – close Boot jumper, follow instruction in
LiteEdite and upload correct software.
2.3 General description
The key feature of InteliDrive Lite is its easy-to-use operation and installation. Predefined
configurations for typical applications are available as well as user-defined configurations for special
applications.
InteliDrive Lite is a comprehensive controller for single engines with extended support of electronic
engines and plug-in modules.