ComAp InteliDrive Lite - Flow Switchdel [S]; Underspeedsd [DISABLED, ENABLED]

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
93
Engine params: Starting RPM
Engine protect: Underspeed
5s
Engine params: Idle time
Engine protect: Eng prot del
Warning level
Shut-down level
RPM
Wrn Underspeed
Sd Underspeed
RPM
RPM
RPM
7.7.7 Flow SwitchDel [s]
Engine is switched to Cooling state when Binary input FlowSwitch is not closed within Flow SwitchDel
after „Running“ (Ready to load) engine state activation.
Step: 1s
Range: 0 - 600s
Default: 5s
7.7.8 UnderspeedSd [DISABLED, ENABLED]
DISABLED: Disables the Wrn Underspeed protection when engine RPM drops below Engine protect:
Underspeed and SdUnderspeed protection in case the engine RPM drops below the Engine params:
Starting RPM.
ENABLED: Function as on the picture above. Default state.
Engine params: Starting RPM
Engine protect: Underspeed
5s
Engine params: Idle time
Engine protect: Eng prot del
Warning level
Shut-down level
R
P
M
S
d
U
n
d
e
r
s
p
e
e
d
R
P
M
R
P
M
R
P
M
RPM = 10
Engine protect: Underspeed Sd = DISABLED
Tables below describe Underspeed protection behavior depends on Underspeed Sd setpoint setting
and RPM value.