ComAp InteliDrive Lite - Sd Engine Temp

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
126
 alarm is not active and
 FAULT RESET is pressed
10.2.32 Sd Engine Temp
Output closes if the water temperature shutdown alarm activates.
The output opens, if
 alarm is not active and
 FAULT RESET is pressed
10.2.33 Wrn Engine Temp
Output closes if the water temperature warning alarm activates.
The output opens, if
 alarm is not active and
 FAULT RESET is pressed
10.2.34 Sd FuelLevel
Output closes if the Fuel level shutdown alarm activates.
The output opens, if
 alarm is not active and
 FAULT RESET is pressed
10.2.35 Wrn FuelLevel
Output closes if the Fuel level warning alarm activates.
The output opens, if
 alarm is not active and
 FAULT RESET is pressed
10.2.36 OFF mode
The output is closed, if OFF mode is selected.
10.2.37 MAN mode
The output is closed, if MAN mode is selected.
10.2.38 AUT mode
The output is closed, if AUT mode is selected.
10.2.39 ServiceTime
Output closes if the ServiceTime alarm activates. Service time is adjusted by setpoint Engine protect:
NextServTime.