InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
Binary outputs of plug-in
ECU alarm Failure Mode Identifier
HINT
The ECU values are not recorded to history.
13.3 Diagnostic messages read from ECU
Diagnostic messages are read and displayed in extra ECU Alarm list. For Standard J1939 SPN
(Suspect Parameter Number), FMI (Failure Mode Identifier) and OC (Occurrence Counter) are shown
together with verbal description if available.
One SPN (Suspect Parameter Number) / FMI (Failure Mode Identify) couple describes one fail
information. If FMI is equal to 0 or 1, WRN is displayed in the ECU Alarm list. For any other FMI
values, FLS is displayed.
Detail SPM/FMI code specification see in:
ï‚· SAE Truck and Bus Control and Communications Network Standards Manual, SAE HS-1939
Publication
 Or refer to corresponding engine manufacturer’s ECU error codes list.
13.4 List of ECU diagnostic codes
HINT
InteliDrive Lite controller doesn’t support J1587 diagnostic line on Volvo engines. This can cause in
some cases a J1939 alarm message FC:000608 due to missing J1587 bus. Contact your Volvo
distributor to update ECU firmware.
For Scania Fault codes (FC) are displayed. Following messages are available for particular groups of
Fault codes:
To Next Page
Loading...
Need help?
General
