ComAp InteliDrive Lite - Load Limit & Engine Protection; Engine Protection Delay

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
68
Condition
Speed request
Binary output
SpeedSwitch
OFF mode
Engine params: Idle speed
=0
MAN mode
Manual
In operation
AUT mode
Automatic by PI loop
In operation
Stop = Not Running
Engine params: Idle speed
In operation
Sd protection
Engine params: Idle speed
In operation
LBI R Reg Disable = 1
Regulator: Reg Bias
In operation
Following example changes the RPM between two levels based on pressure.
6.10.1 Functions 3 and 4
LBI
Active input:
RegRequest2
Switch to RegRequest 2
R Reg Disable
Set PI Regulator output to R Bias
LBO
Function:
Speed Switch
Regulator Comparator output
6.10.2 Functions 3 and 4 setpoints
Regulator
Values
LAI SpeedRequest
OFF
CU: AI1-AI9
AIO: AI1-AI4