InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
7.3.8 IBLite GateIP [-]
IP address of gateway for IB-Lite
7.3.9 IBLite DHCP [DISABLED, ENABLED]
Dynamic Host Configuration Protocol for IP address setting can be used or blocked.
DISABLED: Block the function of DHCP, this option is worth, if you wanna adjust stable IP address
e.g. for WebServer connection or InteliMonitor PC tool.
HINT
Can occured collision of IP addresses in local network with devices as printer, router
etc.!
ENABLED: Dynamically change IP address of the controller after each switch on of the controller.
IP address collision protection. Default state.
7.3.10 ComAp Port [-]
This sepoint is for adjustment of port for ComAp communication over IB-Lite or IL-NT-GPRS module.
Standard ComAp port is 23, what is default value of this setpoint.
7.3.11 APN Name [-]
Name of APN access point for GPRS network
HINT
This information shall provide your telecommunication operator.
7.3.12 APN UserName [-]
User name for APN access point
HINT
This information shall provide your telecommunication operator.
7.3.13 APN UserPass [-]
User password for APN access point
HINT
This information shall provide your telecommunication operator.
7.3.14 AirGate [DISABLED, ENABLED]
The option allows or blocks the function of AirGate. For AirGate function is necessary to use
communication plug-in modules IB-Lite or IL-NT-GPRS or InteliDrive Lite partly supports IB-NT too.
DISABLED: Blocks the function of AIrGate.
ENABLED: Allows function of AirGate. Default state.
7.3.15 AirGate IP [-]
AirGate Address. The default address is „airgate.comap.cz“.
HINT
To Next Page
Loading...
