ComAp InteliDrive Lite - Protection & Failure Outputs; Overspeed & Underspeed Outputs

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
52
Third screen: (Displayed only if is at least one of following AIN configured)
AIN7 (Displayed only if is configured)
AIN8 (Displayed only if is configured)
AIN9 (Displayed only if is configured)
5.9.3 IL-NT-AIO Analog inputs screen
AI1 (AI1 bargraph with protection limits indication, displayed only if is configured)
AI2 (AI2 bargraph with protection limits indication, displayed only if is configured)
AI3 (AI3 bargraph with protection limits indication, displayed only if is configured)
AI4 (AI4 bargraph with protection limits indication, displayed only if is configured)
HINT
This screen is shown/hidden depending on whether the IL-NT-AIO is configured or not.
Analog output AO1 is not displayed on any screen!
5.9.4 InteliDrive Lite Binary inputs
BI1 to BI7
5.9.5 InteliDrive Lite Binary outputs
BO1 to BO7
5.9.6 IL-NT-BIO8 Binary inputs screen
IN: BIO8 BI1 Alarm
IN: BIO8 BI2 Alarm
IN: BIO8 BI3 Alarm
IN: BIO8 BI4 Alarm
IN: BIO8 BI5 Alarm
IN: BIO8 BI6 Alarm
IN: BIO8 BI7 Alarm
IN: BIO8 BI8 Alarm this line is displayed on the following screen
HINT
These screens are shown/hidden depending on whether the IL-NT-BIO8 is configured or not.
5.9.7 IL-NT-IO1 Binary inputs screen
IN: BIO8 BI1 Alarm
IN: BIO8 BI2 Alarm
IN: BIO8 BI3 Alarm
IN: BIO8 BI4 Alarm
HINT
This screen is shown/hidden depending on whether the IL-NT-IO1 is configured or not.
Analog outputs are not displayed on any screen!
5.9.8 ECU State
ECU State
ECU YellowLamp
ECU RedLamp