ComAp InteliDrive Lite - SMS;E-Mail; Yel Alarm Msg [OFF, ON]; Red Alarm Msg [OFF, ON]; Telno;Addr Ch1, 2

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
111
Under limit
Protection is activated only when measured value is under measured level.
Over limit
Protection is activated only when measured value is over measured level.
UnderLimit+fls
Level 2 protection is activated by sensor fail too.
OverLimit+fls
Level 2 protection is activated by sensor fail too.
7.11 SMS/E-Mail
HINT
If a cellular network modem and/or internet bridge is connected to the controller, the controller can
send SMS messages and/or emails in the moment when a new alarm appears in the Alarm list. The
message will contain a copy of the Alarm list.
To enable this function, you should select with setpoints Yel Alarm Msg and Red Alarm Msg, which
levels of alarms shall be announced (red/yellow/both) and also enter valid cellular network phone
number and/or e-mail address to the setpoints TelNo/Addr Ch1 and TelNo/Addr Ch2. It is possible to
put either number or e-mail to both setpoints.
NOTE:
An internet module must be available for sending of e-mails. Similarly, a cellular network modem is
necessary for sending of SMS.
HINT
There are 5 attempts for any active call (SMS/E-Mail). Timeout for connection is 90 sec and after 120
sec controller starts the next attempt. During the time the IL-NT-GPRS is trying to send an active call
type, incoming calls are blocked.
7.11.1 Yel Alarm Msg [OFF, ON]
Set this setpoint to YES if you want to get messages when a yellow (warning) alarm occurs.
HINT
The target address (cellular network phone number or e-mail address) must be set correctly to the
setpoint(s) TelNo/Addr Ch1 resp. TelNo/Addr Ch2.
7.11.2 Red Alarm Msg [OFF, ON]
Set this setpoint to YES if you want to get messages when a red (shutdown) alarm occurs.
HINT
The target address (cellular network phone number or e-mail address) must be set correctly to the
setpoint(s) TelNo/Addr Ch1 resp. TelNo/Addr Ch2.
7.11.3 TelNo/Addr Ch1, 2 […]
Enter either a valid cellular network phone number or e-mail address to this setpoint, where the alarm
messages shall be sent. Type of active call is considered from the value of this parameter. If it consist
„@“ it is supposed to be e-mail address and active e-mail is sent. If the value is number, without „@“, it
is supposed to be the telephone number and active SMS is sent.