InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
NOTE:
The FTDI driver is installed together with LiteEdit.
NOTE:
When the USB cable from the controller is plugged-in first time into different USB ports on the PC
including USB hubs, it can be recognized as new hardware and the drivers are installed again with
different number of the virtual serial port.
CAUTION!
Use shielded USB cable only! (ComAp order code: USB-LINK CABLE 1.8m)
3.5.4 IB-Lite
IB-Lite is a optional plug-in card with Ethernet 10/100 Mbps interface in RJ45 connector. The card is
internally connected to both COM1 and COM2 serial channels and provides an interface for
connecting a PC with LiteEdit or InteliMonitor through Ethernet network, for sending active e-mails and
for integration of the controllers into a building management (Modbus/TCP protocol).
This card also enables to monitor and control the consumption engines over web browser from any
location with internet access using appropriate security measures.
To Next Page
Loading...
