ComAp InteliDrive Lite - IL-NT AIO (Optional Card); IL-NT IO1 (Optional Card); IL-NT BIO8 (Optional Card); IGL-RA15 (Optional Remote Annunciator)

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
147
14.16 IL-NT AIO (optional card)
Plug-in into InteliDrive Lite controller EXTENSION MODULE port.
Resolution 10bits
Inputs
Number of Analog inputs 4 (2400Ohm, 20mA, 4V)
Maximal resistance range 2400Ohm
Maximal voltage range 4V
Current range 0-20 mA
Input impedance (current) 180Ohm for mA measuring
Input impedance (voltage) >68 kOhm for V measuring
Resistance measurement tolerance ±2% ±2 Ohm
Voltage measurement tolerance ±1% ±1mV
Current measurement tolerance ±2% ±0,2mA
Outputs
Number of Analog outputs 1 (21mA, max.load 100Ohm; 4,6V, max.10mA;PWM
500Hz (5V / 10mA)
Voltage measurement tolerance ±1,5% ±10mV
Current measurement tolerance ±2% ±0,1mA
14.17 IL-NT IO1 (optional card)
Plug-in into InteliDrive Lite controller EXTENSION MODULE port.
Number of Analog outputs 4
Analog output range 0 to +VBatt ±1V
Number of Binary inputs 4
14.18 IL-NT BIO8 (optional card)
Plug-in into InteliDrive Lite controller EXTENSION MODULE port.
Number of Binary inputs/outputs 8 (configurable as input or output)
Maximal one Binary output current 0,4A
Maximal total current per module 2,5A
14.19 IGL-RA15 (optional Remote Annunciator)
14.19.1 Power supply
Voltage supply 8-36VDC
Consumption 0,35-0,1A (+1A max horn output), depends on supply
voltage
14.19.2 Operating conditions
Operating temperature -20 +70°C
Storage temperature -30 +80°C