CDM-840 Remote Router MN-CDM840
Ethernet-based Remote Product Management Revision 3
6–23
• Hub RAN Optimizer IP Address – Enter an IP address in the form XXX.XXX.XXX.XXX.
• Hub RAN Optimization E1 Port ID – Enter a numeric identification string for the rear panel
‘G.703 | IN / OUT’ port pair, corresponding to a specified corresponding port on the
CXU-810 RAN Optimizer.
• Optimization Level – Use the drop-down list to select Best Performance or Best
Compression.
• Jitter Buffer Latency – Use the drop-down list to select 10ms, 20ms, 30ms, 40ms, or 50ms.
• Alarm Relay – Use the drop-down list to select Disable or Enable. Select Enable to both
trigger the logging of operational faults or alarms on the Status | Statistics | E1 | Transmit /
Receive pages and toggle on the STORED EVENT LED on the HTTP Interface Virtual Front
Panel (Sect. 6.2.3.2.1.1).
Click [Submit] to save.
E1 Port
Access to G.703 Clock Extension operation defaults to Enable when this FAST option is activated.
Use this drop-down list to otherwise select Disable.
Click [Submit] to save.
To Next Page
Loading...