Comtec CDM-840 - Status | Monitor; Status | Monitor | Events

CDM-840 Remote Router MN-CDM840
Ethernet-based Remote Product Management Revision 3
6–78
6.3.4.2 Status | Monitor Pages
The Monitor pages provide event logging, and operational status windows. Click the Events or
Alarms tab to continue.
6.3.4.2.1 Status | Monitor | Events
Use this read-only page to view the unit alarms summary, input port status, plus a scrollable
window that displays any events and alarms as logged by the unit during normal operation.
Figure 6-41. Status | Monitor | Events Page
Alarms
This section summarizes the Unit, Tx, Rx, BUC (when installed), LNB (when installed), and Traffic
alarms compiled since the logging buffer was last cleared.
Events
The “STORED EVENT” LED on the physical and virtual front panels lights amber to
indicate the presence of any stored event(s) or alarm(s).
Each logged event or alarm is Date- and Time-stamped, and a Description is provided.
Click [Clear Event Table] to delete all existing logged entries from the Events log. The log and
counter then resets to a single entry: “INFO – Event Log Cleared”.