Comtec CDM-840 - Compatible Features and Detailed Specifications

CDM-840 Remote Router MN-CDM840
Appendix E Revision 3
E–13
E.8 Compatible Features and Detailed Specifications
Advanced VSAT BPM Mode is compatible with the following features:
Group QoS (CTOG-250) and Return QoS (CDM-840)
Header Compression
Includes the following L2 Protocols:
• Ethernet 2.0 • Ethernet 2.0+VLAN-tag
• Ethernet 2.0+VLAN-tag+VLAN-tag • Ethernet 2.0+MPLS
• 802.3-raw • 802.3-raw+VLAN-tag
• 802.3-raw+VLAN-tag+VLAN-tag • 802.3+802.2
• 802.3+802.2+VLAN-tag • 802.3+802.2+VLAN-tag+VLAN-tag
• 802.3+802.2+SNAP • 802.3+802.2+SNAP+VLAN-tag
• 802.3 +802.2+SNAP+VLAN-tag+VLAN-tag • 802.3+802.2+SNAP+MPLS
Includes the following L3/L4 Protocols:
• IP, UDP, TCP, RTP
Payload Compression
PTP (Precision Timing Protocol)
RANOP with E1
dSCPC with VMS
ECM (Entry Channel Mode)
AES-128
Return Link ACM
ACM/VCM on the Outbound
Comtech Dynamic Routing Protocol (for the management network)
Multicast
IPv6 (traffic ports only)
VLAN trunking
VLAN Access Mode on the CDM-840
The following features are
not
supported when in BPM Mode:
• The standalone CDM-800* does not support BPM due to packet per second limitations.
• Single Hop-on-Demand (SHOD) Mesh.
• CDD-880 Port Diversity.
*Starting with Firmware Ver. 1.5.1.X, the CDM-800 no longer supports standalone
mode. The CDM-800 must be paired with a CTOG-250.