CDM-840 Remote Router MN-CDM840
Ethernet-based Remote Product Management Revision 3
6–84
6.3.5.2 Utility | Carrier ID
Appendix F. CARRIER ID (DVB-CID METACARRIER®)
Figure 6-44. Utility | Carrier ID Page
Carrier ID
• Mgmt MAC Address – This is the read-only MAC Address for the CDM-840’s M&C card.
• Latitude – Set the modem’s physical location in Latitude in the form DDMM.mmC, where:
o DD = degrees (00 to 90);
o MM.mm = whole (00 to 60) and fractional (0 to 99 – tenths or hundredths) minutes;
o C = Use the drop-down list to set the compass cardinal point as North or South.
• Longitude – Set the modem’s physical location in Longitude in the form DDDMM.mmC,
where:
o DDD = degrees (000 through 180);
o MM.mm = whole (00 to 60) and fractional (0 to 99 – tenths or hundredths) minutes;
o C = Use the drop-down list to set the compass cardinal point as East or West.
• Enter a Telephone Number to provide a valid emergency contact number to call to resolve
operational issues – e.g., in case the modulator’s Tx output is causing interference on the
satellite. Providing this phone number allows a satellite operator to quickly call the
person(s) responsible for correcting any issues.
• Create a Custom Message to provide additional information that may be useful in resolving
operational issues, e.g., to quickly resolve interference.
Click [Submit] to save.
To Next Page
Loading...