Comtec CDM-840 - Vipersat Management System (VMS) Commands and Queries

CDM-840 Remote Router MN-CDM840
Serial-based Remote Product Management Revision 3
7–31
7.3.12 Vipersat Management System (VMS) Commands and Queries
Parameter
Type
Command
(Instruction
Code
& Qualifier)
Number of
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code &
Qualifier)
Response to Query
(Target to Controller)
VMS Network ID
N/A
3 bytes
Query only.
Returns the VMS Network ID for the unit in the form xxx, where:
xxx=value from 1 to 254
EXAMPLE: <0/VID?[cr]
>0000/VID=100[cr][lf]
N/A
VID?
VID=xxx
(see Description
of Arguments)
VMS
Management
(UDP) Base port
VMP=
5 bytes
Command or Query.
Sets or returns the VMS Management (UDP) Base port for the unit in the
form xxxxx, where:
xxxxx=value from 49152 to 65534
EXAMPLE: <0/VMP=49155[cr]
VMP=
VMP?
VMP*
VMP#
VMP?
VMP=xxxxx
(see Description
of Arguments)
VMS
Management
Multicast
address
N/A
15 bytes
Query only.
Returns the VMS Multicast IP Address in the form xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx=the IP Address
EXAMPLE: <0/VMI?[cr]
>0000/VMI=239.001.001.004[cr][lf]
N/A
VMI?
VMI=xxx.xxx.xxx.xxx
(see Description
of Arguments)