Comtec CDM-840 - Configuration | Interface | E1; Configuration | Interface | E1 | Configuration

CDM-840 Remote Router MN-CDM840
Ethernet-based Remote Product Management Revision 3
6–22
6.3.3.1.3 Configuration | Interface | E1 Pages
Appendix K. RAN/WAN OPTIMIZATION
These pages are functional only when the “G.703 E1 Interface / RAN Optimization”
FAST and hardware options are installed and activated.
Click the Configuration or Time Slots tab to continue.
6.3.3.1.3.1 Configuration | Interface | E1 | Configuration
Figure 6-14. Configuration | Interface | E1 | Configuration Page
E1 Configuration
• Line Type – Use the drop-down list to select Framed, Framed-CRC, or Unframed.
• Line Coding – Use the drop-down list to select HDB3 or AMI.
• WAN Loopback and Terrestrial Loopback – Use the drop-down lists to select Disable or
Enable.
Click [Submit] to save.
RAN Optimization
Appendix K. RAN/WAN OPTIMIZATION
Use RAN Optimization to reduce the satellite bandwidth required for mobile backhaul. Use this
section to select the level of optimization needed to achieve the desired link quality and
bandwidth savings.