Comtec CDM-840 - Admin | SNMP; Figure 6-7. Admin | SNMP Page

CDM-840 Remote Router MN-CDM840
Ethernet-based Remote Product Management Revision 3
6–13
6.3.2.2 Admin | SNMP
Sect. 6.2.2 SNMP Interface
The Administrator must use this page to manage the CDM-840 SNMP (Simple Network
Management Protocol) settings.
Figure 6-7. Admin | SNMP Page
SNMP Configuration
• Enter an SNMP Trap Destination IP Address in the form XXX.XXX.XXX.XXX.
Click [Submit] to save.
• Enter an SNMP Read Community string. This string can be any combination of characters
and a length of 4 to 15 characters. The factory default string is public.
Click [Submit] to save.
• Enter an SNMP Write Community string. This string can be any combination of characters
and a length of 4 to 15 characters. The factory default string is private.
Click [Submit] to save.