CDM-840 Remote Router MN-CDM840
FAST Activation Procedure Revision 3
5–3
5.2.1 FAST Configuration
The read-only table in this section displays the CDM-840 available FAST Features and the
operational status for each option:
This column lists each available FAST Feature.
This column identifies each FAST Feature operational parameter(s). If an option is not enabled,
the column displays this information.
The complete roster of FAST Accessible Options is as follows:
CCM (VersaFEC only)
16 kbps – 256 kbps Tx Data/Symbol Rate
16 kbps – 512 kbps Tx Data/Symbol Rate
16 kbps – 1024 kbps Tx Data/Symbol Rate
16 kbps – 2.048 Mbps Tx Data/Symbol Rate
16 kbps – 5 Mbps Tx Data/Symbol Rate
16 kbps – 10 Mbps Tx Data/Symbol Rate
16 kbps – 15.35 Mbps Tx Data/Symbol Rate
CCM (DVB-S2 only)
1 – 15 Mbps Rx Data/Symbol Rate
1 – 45 Mbps Rx Data/Symbol Rate
1 – 100 Mbps Rx Data/Symbol Rate
E1 Interface Full Support E1 (hardware upgrade also required)
G.703 Clock Extension
dSCPC (Dynamic Single Carrier per Channel)
1)
Tx Header and Payload Compression and Quality of Service (QoS)/Advanced QoS
are standard (non-FAST) operational features for Comtech EF Data’s Advanced
VSAT Series group of products. If these features are listed in the FAST
Configuration table, they are always indicated as Enabled.
2) E1 Interface operation is not available with the ODMR-840 Reduced Form Factor
Outdoor Remote Router.
To Next Page
Loading...