CDM-840 Remote Router MN-CDM840
Appendix M Revision 3
M–17
M.3 DPC Operation
Dynamic Power Control and ACM work independent of one another. This gives you the option to
run DPC with or without ACM. This section assumes all other operational parameters have been
previously configured.
For detailed information, see:
• Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT and Chapter 7.
SERIAL-BASED REMOTE PRODUCT MANAGEMENT in this manual.
• Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT and Chapter 7.
SERIAL-BASED REMOTE PRODUCT MANAGEMENT in the CDD-880 Multi Receiver
Router Installation and Operation Manual (CEFD P/N MN-CDD880)
• VMS v3.x.x VIPERSAT Management System User Guide (CEFD P/N MN/22156)
The CDD-880 and CDM-840 provide several means for configuring Dynamic Power Control
operation via Remote Product Control with a user-supplied PC:
• CDD-880 and CDM-840 HTTP (Web Server) Interfaces using a compatible Web browser.
• Ethernet-based Simple Network Management Protocol (SNMP) using a Network
Management System (NMS) and Management Information Base (MIB) File Browser.
• Serial-based Remote Control Interface using a terminal emulation program or Windows
Command-line.
COMTECH EF DATA STRONGLY ENCOURAGES USE OF THE CDD-880 AND CDM-840
HTTP INTERFACES FOR MONITOR AND CONTROL (M&C) OF THE CDD-880 AND THE
CDM-840. COMTECH EF DATA RECOMMENDS USE OF THE SERIAL-BASED REMOTE
CONTROL INTERFACE AND THE ETHERNET-BASED SNMP INTERFACE ONLY FOR
ADVANCED USERS.
THE HTTP INTERFACE FIGURES AS FEATURED THROUGHOUT THIS APPENDIX ARE
INTENDED FOR USER REFERENCE ONLY AND ARE SUBJECT TO CHANGE. THE
FIRMWARE INFORMATION (I.E., REVISION LETTERS, VERSION NUMBERS, ETC.) AS
DISPLAYED MAY DIFFER FROM YOUR SETUP.
To Next Page
Loading...