Comtec CDM-840 - Bulk Configuration String Commands

CDM-840 Remote Router MN-CDM840
Serial-based Remote Product Management Revision 3
7–29
Parameter
Type
Command
(Instruction
Code
& Qualifier)
Number of
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code &
Qualifier)
Response to Query
(Target to Controller)
Unit Test
Mode
TST=
1 byte
Command or Query.
Sets or returns Unit Test Mode in the form x, where:
0=Normal Mode (no test)
1=Tx CW
2=Tx Alternating 1,0 Pattern
3=QPSK PN Pattern
EXAMPLE: <0/TST=1[cr]
TST=
TST?
TST*
TST#
TST?
TST=x
(see Description of
Arguments)
7.3.10 Bulk Configuration String Commands
Parameter
Type
Command
(Instruction
Code
& Qualifier)
Number of
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code &
Qualifier)
Response to Query
(Target to Controller)
Configuration
Load
CLD=
1 byte
Command only.
Retrieves a previously stored modem configuration from the Configuration
Memory location specified in the form x, where:
x=0 to 9.
EXAMPLE: <0/CLD=4[cr]
CLD=
CLD?
CLD*
CLD#
N/A
N/A
Configuration
Save
CST=
1 byte
Command only.
Stores the current modem configuration into the Configuration Memory location
specified in the form x, where:
x=0 to 9.
EXAMPLE: <0/CST=0[cr]
CST=
CST?
CST*
CST#
N/A
N/A