Comtec CDM-840 - Page 165

CDM-840 Remote Router MN-CDM840
Ethernet-based Remote Product Management Revision 3
6–83
Click [Submit] to save the BERT settings and execute the test.
BERT Monitor
This section displays the ongoing BERT.
• Click [Restart] to restart the BERT Monitor.
• Click [Update] to refresh a test that is already in progress.
The CDM-840 does not accept IP traffic while a BERT is in progress.
Redundancy
Redundancy is available only when an optional Comtech EF Data CRS-170A or
CRS-180 Redundancy Switch is installed, and the CDM-840 is recognized as part of a
1:1 or 1:N redundant pair.
Console Configuration
• Console Configuration – Use the drop-down list to set the EIA-232 or EIA-485
communication parameters for the rear panel DB-9M serial ‘CONSOLE’ port:
o RS232-8N1-38400
o RS232-8N1-57600
o RS232-8N1-115200
o
RS485-8N1-9600
o
RS485-8N1-19200
o
RS485-8N1-38400
o RS485-8N1-57600
o RS485-8N1-115200
Click [Submit] to save.