CDM-840 Remote Router MN-CDM840
Ethernet-based Remote Product Management Revision 3
6–56
• Query Interval (1 to 60) – Enter a value, in seconds. The default is 1 second. This is the
interval between general queries sent by the unit. By varying the query interval, the
administrator may tune the number of IGMP messages on the subnet; note that larger
numbers cause the IGMP queries to be sent less often.
• Query Response Interval (1 to 25) – This is the maximum response time inserted into the
periodic general queries. By varying the Query Response Interval, the administrator may
tune the “burstiness” of IGMP messages on the subnet; note that larger values make the
traffic less “bursty” as host responses are spread out over a large interval.
The number of seconds assigned to the Query Response Interval must be less
than the Query Interval.
Click [Submit] to save.
IGMP Table
This read-only table lists the IGMP Groups that are active on the unit. This allows you to
determine which services are being used and the minimum time before a service will be
terminated.
Click [Refresh] to update this section with its latest available statistics.
To Next Page
Loading...