Comtec CDM-840 - Page 327

CDM-840 Remote Router MN-CDM840
Appendix K Revision 3
K–7
K.2.2.1 Performance Monitoring via the CDM-840 HTTP Interface
Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
YOU MAY PROCEED WITH ETHERNET-BASED REMOTE PRODUCT MANAGEMENT,
ASSUMING THAT:
• YOUR CDM-840 IS OPERATING WITH THE LATEST VERSION FIRMWARE FILES.
• YOUR CDM-840 IS CONNECTED TO A USER-SUPPLIED, WINDOWS-BASED PC AS
FOLLOWS:
O THE PC SERIAL PORT IS CONNECTED TO THE CDM-840 REAR PANEL
‘CONSOLE’ PORT WITH A USER-SUPPLIED SERIAL CABLE.
o THE PC ETHERNET PORT IS CONNECTED TO THE CDM-840 REAR PANEL
‘ETHERNET | MANAGEMENT | FE’ ETHERNET PORT WITH A USER-SUPPLIED
HUB, SWITCH, OR DIRECT ETHERNET CABLE CONNECTION.
O
THE PC IS RUNNING A TERMINAL EMULATION PROGRAM (FOR OPERATION
OF THE CDM-840 SERIAL INTERFACE) AND A COMPATIBLE WEB BROWSER
(FOR OPERATION OF THE HTTP INTERFACE).
• YOU HAVE NOTED THE CDM-840 MANAGEMENT IP ADDRESS USING THE
CDM-840 SERIAL INTERFACE.
• YOU HAVE PRUCHASED AND ACTIVATED THE E1 RAN OPTIMIZATION FAST
FEATURE.
The RAN Optimizer collects detailed usage and performance statistics that are accessible from
the CDM-840 HTTP Interface.
Error! Reference source not found. shows the CDM-840 HTTP
Interface “splash” page, and the menu tree for accessing this monitoring feature. Page
functionality that is not specific to this operation appears dimmed.