CDM-840 Remote Router MN-CDM840
Updating Firmware Revision 3
4–10
• Click [Submit] to save the setting.
b) Reboot the CDM-840:
• Go to either the CDM-840 HTTP Interface ‘Admin | Firmware’ page (in the System
Reboot section) or the ‘Utility | Reboot’ page:
• Click [Reboot] to reboot the unit. A dialogue box
appears to prompt continuation or cancellation of the
reboot process:
Click [OK] to continue the reboot process, or [Cancel] to abort the process and
return to the Utility | Reboot page.
Once the reboot process resumes, the Utility | Reboot page is replaced with the
dynamic message “Please wait... CDM-840 is rebooting. Login will be required in
XX seconds” – the time count decrements to 0 seconds before the unit reboots.
After the reboot, login is required once again to resume use of the HTTP Interface.
The CDM-840 is now operating with its latest firmware. The firmware update process is now
complete.
To Next Page
Loading...