Comtech EF Data cdm-570a - Protocol Configuration; Protocol Configuration > IGMP Information

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Revision 5
Optional Packet Processor - Serial/Telnet CLI Operation 9–34 MN-CDM570A
9.3.6 Protocol Configuration
Open the Protocol Configuration Page from the Main Menu.
Figure 9-23. Protocol Configuration
Selection
Hot Key
Description
IGMP
I
Displays the IGMP page.
See Section 9.3.6.1.
ARP
A
Displays the ARP Table Utilities page.
See Section 9.3.6.2.
DHCP Server IP Address
R
Allows entry of the DHCP server IP address.
Allows hosts on a remote LAN to send DHCP request packets to the DHCP
server so that the DHCP server can dynamically assign IP addresses to
remote hosts.
Brouter Mode
B
Displays the Brouter Configuration page.
See Section 9.3.6.3.
9.3.6.1 Protocol Configuration > IGMP Information
Open the nested IGMP Information page from the Protocol Configuration page.
Use this page to view the IGMP clients that are actively listening to content being provided by the
Packet Processor. It also allows you to determine how the Ethernet Interface is configured either
to receive requests to join IGMP groups or announce groups for others to join.
Figure 9-24. IGMP Information