Ethernet Interface Operation Revision 4
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
7–28
Click [Submit Changes] to save.
Add Static ARP
This section allows you to directly add a static ARP entry should you choose to hard-code an
association of an IP address to a particular MAC address. Note that the index automatically
increments to the next available number.
This is the read-only internal table index number. It is automatically assigned.
Enter a valid IP Address in the format XXX.XXX.XXX.XXX.
Enter a valid MAC-48 Address in the format YY:YY:YY:YY:YY:YY.
Click [Add Entry] to save.
Delete Static ARP
If a static ARP entry (created using Add Static ARP) is no longer required, Enter Entry Index to
Delete and click [Delete Entry] to execute removal of that entry.
Flush Dynamic ARPs
You may use this function if there is a conflict on the network and/or MAC addresses are now
associated with new and different IP addresses.
Click [Flush ARP Table] to delete all dynamically learned ARP entries.
To Next Page
Loading...
