FAST Activation Procedure Revision 4
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
5–2
5.2 About FAST Options
The FAST options are linked to three option registers:
• Register 1 is for Data Rate, ACM, and CnC options;
• Register 2 is for Modulation and Demodulation types, Optical Interface, and AUPC options.
• Register 3 is for the K4 GZip lossless compression and decompression, Net Spec (DVB-S2,
DVB-S2-EB1/EB2X Network Specification), and DPD options.
Note the following:
• When a FAST Access Code is obtained from Comtech EF Data, it will be for a specific
register.
• The CnC and K4 GZip FAST options require installation of the respective option card into the
internal modem board.
5.3 FAST Activation Procedure
5.3.1 FAST Activation Using the CDM-760 Front Panel
See Chapter 6. FRONT PANEL OPERATION for complete information about using
this product management interface.
Do these steps:
1. Before contacting Comtech EF Data Product Support to order FAST feature upgrades, obtain
and record the modem’s baseboard serial number:
a. Use the front panel◄►arrows keys to navigate to the SELECT: FAST menu, and then
press ENTER.
b. The modem’s 9-digit “Baseboard S/N” is displayed on the left hand side of the bottom
line, as shown in this example:
FAST: Options Demo-Mode CnC (◄ ►)
Baseboard S/N 012345678 Hw Rev##.##
c. Record the Serial Number: ______________________________________
2. To view currently installed FAST features, do these steps from the top-level SELECT: FAST
menu:
a. Use the ◄►arrows keys to select OPTIONS, and then press ENTER:
FAST 1: Set View 2: Set View
OPTIONS 3: Set View (◄ ►▲▼)
b. Use the ◄►arrows keys to select View for the desired register #, and then press
ENTER.
c. Use the ▲▼arrow keys to scroll through the list of available FAST options. Options are
identified as ‘Installed’ or ‘Not Installed’. Any option listed as ‘Not Installed’ may be
purchased as a FAST upgrade.
To Next Page
Loading...
