Comtech EF Data CDM-760 - ACM Configuration and Operation Using Serial Remote Control Commands;Queries

Appendix G Revision 4
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
G–30
G.5.4.2 ACM Configuration and Operation Using Serial Remote Control
Commands/Queries
The operands available through the CDM-760 Serial Interface are identified in the following table –
details on using these remote commands and queries are explicitly defined in Chapter 8.
Operand
Description
ACM
Sets or reports ACM operating parameters.
ADC
Sets or reports ACM degradation-on-configuration parameters.
RES
Reports the value of the remote demod Es/No, in dB.
LES
Reports the value of the local Es/No, in dB.
TMC
Sets or reports Tx modulation (TMC=00 is ACM mode)
RMC
Sets or reports Rx demodulation (RMC=00 is ACM mode)
MGC
Reports the global modem configuration, including ACM Operating Parameters and ACM
Degradation Configuration
EID
Reports the equipment ID and installed options, including ACM