Updating Firmware Revision 4
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
4–7
4.2.1.4.4 Use Windows Command-line or Command Prompt to Make a
Folder
Select Start on the Windows taskbar and then do these steps:
1. Click Run... to open the Run window (or, depending on Windows OS version prior to
Windows 95, click the MS-DOS Prompt icon from the Main Menu).
2. Open a Command-line window:
• For Windows 95 or Windows 98 – type “command”.
• For any Windows OS versions later than Windows 98 – type “cmd” or “command”.
• Alternately, from Start, select the All Programs > Accessories popup submenu, and then
select Command Prompt:
3. From the c:\> prompt, type either “mkdir CDM760” or “md CDM760” (both “mkdir” and
“md” mean “make directory”), and then press Enter.
There will now be a “CDM760” folder created and available for placement of the firmware file
download.
4.3 Download and Extract the Firmware Update Files
Do these steps:
1. Go online to
www.comtechefdata.com.
2. On the Main page – Under Support Information or the Support tab, select the Software
Downloads hyperlink.
3. On the Software Downloads page – Click Download Flash and Software Update Files.
4. On the Flash Updates Index page – Select the (Select a Product Line) Satellite Modems
hyperlink.
5. On the Satellite Modems product page – Select the CDM-760 product hyperlink.
6. Select the appropriate firmware archive EXE or ZIP file download hyperlink (see Section
4.1.1).
To Next Page
Loading...
