Serial Interface Operation Revision 3
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
8–23
Parameter Type
Arguments for
Command or
Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of Arguments)
Command Query
Response to
Command
Response to
Query
unread Stored
Events (cont.)
hhmmss=time stamp.
NOTE: If there are less than five events to be retrieved, the remaining positions are padded with zeros. If there are no
new events, the response is RNE*.
Forces the software to clear the events log.
THIS COMMAND TAKES NO ARGUMENTS.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored events log.
THIS COMMAND TAKES NO ARGUMENTS.
Sets or returns the EventLog Style in the form x, where:
0=Fill and Stop (DEFAULT)
1=Fill and Roll-over
EXAMPLE: <0/ELS=0 (sets EventLog to Fill and Stop)
Sets or returns the IP Address and network prefix for the 10/100 Base-T Ethernet management port, in the form
aaa.bbb.ccc.ddd.yy, where:
aaa=000-223
bbb=000-255
ccc=000-255
ddd=000-255
yy=network prefix (value from 8 to 31)
EXAMPLE: <0/IPA=010.006.030.001.24
Sets or returns the IP Gateway Address for the Ethernet management port in the form aaa.bbb.ccc.ddd where:
aaa=000-223
bbb=000-255
ccc=000-255
ddd=001-255
EXAMPLE: <0/IPG=010.006.030.001
Returns the unique MAC Address for the modem in the form aabbccddeeff.
EXAMPLE: <0/MAC?
<0000/MAC=0006B00001C2
To Next Page
Loading...
