Serial Interface Operation Revision 3
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
8–25
Parameter Type
Arguments for
Command or
Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of Arguments)
Command Query
Response to
Command
Response to
Query
Enables or disables flow control in the form x, where:
0=Disable GBEI Flow Control
1=Enable GBEI Flow Control
NOTE: Applies to all ports.
Enables or disables MAC address learning in the form x, where:
0=Disable MAC learning
1=Enable MAC learning
NOTE: Applies to all ports.
Sets or returns SNMP read community string.
NOTE: Empty string is not allowed
Sets or returns SNMP write community string.
NOTE: Empty string is not allowed.
Sets or returns SNMP traps community string.
NOTE: Empty string is not allowed
Sets or returns the IP address of the first SNMP Trap destination IP Address 1 where traps will be sent, in the form
xxx.xxx.xxx.xxx.
EXAMPLE: <0/STA=010.006.030.001 (if not configured, returns 000.000.000.000)
Sets or returns the IP address of the SNMP Trap destination IP Address 2 where traps will be sent, in the form
xxx.xxx.xxx.xxx.
EXAMPLE: <0/STB=010.006.030.001 (if not configured, returns 000.000.000.000)
Sets or returns SNMP System Contact string.
EXAMPLE: <0/SSC=Joe Net Admin (if not configured, returns empty string: <0/SSC=)
Sets or returns SNMP System Name string.
EXAMPLE: <0/SSN=Remote1 (if not configured, returns empty string: <0/SSC=)
Sets or returns SNMP System Location string.
EXAMPLE: <1/SSL=Upstairs back right (if not configured, returns empty string: <0/SSL=)
To Next Page
Loading...
