AH500 Module Manual
9-4
Number Name Description
8 MS LED indicator LED indicator
9 RJ45 port 1 RJ45 port 1
10 RJ45 port 2 RJ45 port 2
11 Label Nameplate
12 Set screw Fixing the module
13 Connector Connecting the module and a backplane
14 Projection Fixing the module
9.1.5 RJ-45 Port
Pin Definition Description
1
Tx+ Transmitting data +
2
Tx- Transmitting data -
3
Rx+ Receiving data +
4
-- N/C
5
-- N/C
6
Rx- Receiving data -
7
-- N/C
8
-- N/C
9.2 Installation and Wiring
This section introduces the installation of AH10/15EN-5A, and the connection of AH10/15EN-5A to
the network.
9.2.1 Installation
Installing AH10/15EN-5A on a main backplane:
Insert a module into a slot, make sure that the module is installed on the backplane properly, and
tighen the the screw, as illustrated below.
1. Insert the projection under the module into the hole in the backplane.
2. Push the module in the direction indicated by the arrow until it clicks.
To Next Page
Loading...
