Delta AH500 - Connecting PROFIBUS-DP Connector

Chapter 13 PROFIBUS Slave Module AH10PFBS
13-5
 Install AHPS05-5A and the AH500 series CPU module to the POWER interface and CPU
interface on the rack respectively according to the above steps and the figure is shown as
below after the installation is over.
13.3.3 Connecting PROFIBUS-DP Connector
 Insert the PROFIBUS-DP bus connector in the direction indicated by the following arrow to
AH10PFBS-5A communication port. Tighten the screw on the PROFIBUS-DP bus connector
so as to ensure the connection between AH10PFBS-5A and PROFIBUS-DP bus is reliable.