Chapter 10 DeviceNet Communication Module AH10DNET
10-43
10.9.2 Configuration of DeviceNet Slave
1. PC accesses an AH500 series CPU module via RS232 after connecting the device according to
the following figure.
RS232
DeviceNet Builder
CPU530-EN
PS05
P 05S
C U530-ENP
10DNET
AH10DNET-5A
Note: AH10DENT-5A on the right of AHCPU530-EN will serve as the slave and therefore the
RS232 communication cable must be connected to AHCPU530-EN.
2. Open ISPSoft; select “Tool” >> “Communication Setting” and then the following dialogue box will
pop up. Select the already built driver and then click “OK”.
3. Select “File” >> “New” >> “New” and the following dialogue box will appear. Click “OK” after
selecting the corresponding PLC model.
To Next Page
Loading...
