Delta AH500 - Special Operation in Master Mode; Master Mode Setting

Chapter 10 DeviceNet Communication Module AH10DNET
10-19
10.7 Special Operation in Master Mode
10.7.1 Master Mode Setting
If AH10DNET-5A is in slave mode, it can be set to the master mode via the DeviceNet Builder
software.
1. PC accesses an AH500 series CPU module via USB after connecting the device according to
the following figure.
RS232
DeviceNet Builder
CPU530-EN
PS05
P 05S
C U530-ENP
10DNET
AH10DNET-5A
Note: The introduction in this section is made in the USB communication method.
2. Open ISPSoft, select “File” >> “New” >> “New” and then the following dialog box appears where
select the corresponding PLC.
Note: The PLC used in this section is AHCPU530-EN.