AH500 Module Manual
10-20
3. Select “Tool” >> “Communication Setting” and then the following dialog box appears where
select the already built driver.
Note: The driver is built via COMMGR software. See section 8.1.4 in the help file of the
DeviceNet Builder software for more.
4. Double click “HWCONFIG” symbol in the above window and then a new interface pops up,
where select “Option” >> “I/O Scan” and then the icon of AH10DNET-5A will emerge as below.
Note: AH10DNET-5A could be installed to other slot.
To Next Page
Loading...
