Delta AH500 - LED Indicators

Chapter 3 Analog Output Module AH04DA/AH08DA
3-17
*3. Please connect the ground in the shielded cable to the terminal SG.
*4. Once AH08DA-5B is installed on a backplane, the connection between the terminal SG on AH08DA-5B
and the terminal on the backplane will be a short circuit. Please connect the terminal on the
backplane to the ground terminal .
(3) AH08DA-5C
Cur re nt outp ut
A
C
m
o
t
o
r
d
rive
,
, recorder
...proportion in g val ve
AC moto r dr ive ,
, recorder
...proportion in g val ve
IO0
AG
CH0
0mA~20mA
CH0
AG
ZP
U P
24VDC
DC/DC
converter
+15V
-15V
AG
SG
CH7
0mA~20mA
CH7
AG
IO7
AG
*2
SG
*2
SG
*3
Cur re nt outp ut
Shieldedcable 1*
Shieldedcable 1*
*1. Please use a shielded cable as an analog output cable, and isolate the shielded cable from other power
cables.
*2. Please connect the ground in the shielded cable to the terminal SG.
*3. Once AH08DA-5C is installed on a backplane, the connection between the terminal SG on AH08DA-5C
and the terminal
on the backplane will be a short circuit. Please connect the terminal on the
backplane to the ground terminal
.
3.3.4 LED Indicators
Number Name Description
1
RUN LED
indicator
Operating status of the module
ON: The module is running.
OFF: The module stops running.
2
ERROR LED
indicator
Error status of the module
ON: A serious error occurs in the module.
OFF: The module is normal.
Blink: A slight error occurs in the module.