Delta AH500 - Control Request; Connecting AH10 PFBS-5 A to the PROFIBUS-DP Network

Chapter 13 PROFIBUS Slave Module AH10PFBS
13-15
13.9 Application Example 1
13.9.1 Control Request
Complete the data exchange between S7-300 (Siemens PLC) and AHCPU530-EN through the
PROFIBUS-DP network.
13.9.2 Connecting AH10PFBS-5A to the PROFIBUS-DP Network
1. Siemens S7-300 serves as the PROFIBUS-DP master and AH10PFBS-5A+AHCPU530-EN
serves as the slave in this example.
PROFIBUS-DP network figure:
2. Set the PROFIBUS node address of AH10PFBS-5A to 1.
3. Insert AH10PFBS-5A to the I/O interface of the main AH500 series rack and ensure that the
AH500 series CPU module is connected to AH10PFBS-5A normally.
13.9.3 Applied Software
 ISPSoft is one of the PLC programming software of Delta. Users can download it at Delta
website and click the following link to enter the download page. http://www.deltaww.com/
 Siemens S7-300 is used as the PROFIBUS-DP master and Siemens PLC software Step 7 is
taken as an example for an introduction.