Chapter 10 DeviceNet Communication Module AH10DNET
10-49
10.9.3 Configuration of DeviceNet Master
1. Connect the devices following the figure below and remove the RS232 cable from
AHCPU530-EN to AHCPU510-EN.
RS232
DeviceNet Builder
CPU510-EN
PS05
P 05S
C U510-ENP
10DNET
AH10DNET-5A
Note: AH10DENT-5A on the right of AHCPU510-EN is used as the master and therefore the
RS232 cable must be connected to AHCPU510-EN.
2. Open ISPSoft; select “Tool” >> “Communication Setting” and then the following dialogue box will
pop up. Select the already built driver and then click “OK”.
3. Select “File” >> “New” >> “New” and the following dialogue box will appear. Click “OK” after
selecting the corresponding PLC model.
To Next Page
Loading...
